Cisco ios 15.0
Compatibility checks ensure that features that are supported across members of a stack usingĪ forwarding ASIC with different capabilities will function The show platform stack compatibility commands display feature incompatibility information between (Optional) Displays switch-level independent, system-level interdependent or port-level independent features with the specified feature ID.ĭisplays system-level interdependent features.ĭisplays port-level independent features. Syntax Description allĭisplays switch-level independent features.
Cisco ios 15.0 software#
Stack-manager command in privileged EXEC mode. 4 Release Notes for Cisco 800 Series Routers with Cisco IOS Release 15.0(1)XA OL-20855-06 New and Changed Information New Software Features in Cisco IOS Release 15. Related CommandsĪccesses a specific stack member from the stack master.
Cisco ios 15.0 upgrade#
For information about using FIPS certifies images, see the 'Boot Loader Upgrade and Image Verification for the FIPS Mode of Operation' section in the 'Assigning the Switch IP Address and Default Gateway' chapter of the software configuration guide.
You also can use the remote command stack-member-number LINE privileged EXEC command on the stack master switch to enable debugging on a member switch without first starting a session. Note The images for the Cisco IOS Release 15.0(2)EZ on the Catalyst 2960-P switch are FIPS certified. Enter the debug command at the command-line prompt of the stack member. To enable debugging on a stack member, you can start a session from the stack master by using the session switch-number privileged EXEC command. After doing some reading it appears that Cisco is going to a pay for the licensing functionality that you want. The vulnerability is due to how an affected device processes. We use Cisco C3560, 2960, 4506 and I was noticing that IOS 15.0.x is available. CVE-2017-12237 : A vulnerability in the Internet Key Exchange Version 2 (IKEv2) module of Cisco IOS 15.0 through 15.6 and Cisco IOS XE 3.5 through 16.5 could allow an unauthenticated, remote attacker to cause high CPU utilization, traceback messages, or a reload of an affected device that leads to a denial of service (DoS) condition. Not all Catalyst 37 switches can run this release. I am upgrading the network equipment at my place of employment. 2960-Plus switches and on Cisco EtherSwitch service modules. When you enable debugging on a switch stack, it is enabled only on the stack master. Cisco IOS Release 15.0 (2)SE and later runs on Catalyst 3750, 3560, 3560-C, 2960, 2960-S, 2960-C, and. The undebug platform remote-commands command is the same as the no debug platform remote-commands command. All other platforms are now end-of-life and only support IOS 12.4. This command has no arguments or keywords. x Only the c7200 series get newer IOS 15 images. No debug platform remote-commands Syntax Description To disable debugging, use the no form of this command. To enable debugging of remote commands, use the debug platform remote-commands command in privileged EXEC mode.
Stack Manager Commands debug platform remote-commands